CANBus system with two digital channels. Includes AMPSEAL connector, matching loom, pigtailed Transmitter and carbon fibre paddle plate for minimal weight and maximum stiffness.

Fully assembled* with two paddleshift switches and a choice of carbon fibre levers ready to bolt onto your steering wheel boss.

A revolution in wireless steering wheel controls, for kit cars and race cars.

Main Features

gear shift control via CAN signalling

After you place your order, we will contact you to confirm your lever choice.

*steering wheel not included and is shown for illustration purposes only.

FREEWheel USB configuration software.zip
Paddle plate.pdf
Kit Car Electronics paddle shifter datasheet.pdf
KCE_WirelessCAN_Kvaser_dbc.zip
FREEWheel CAN installation instructions.pdf
KCE_WirelessCAN_ECUMaster.zip
KCE_WirelessCAN_AIM_xc1.zip
CAN AMPSEAL 8-pin connector pinout diagram.pdf
FREEWheel USB config tool Windows driver.zip
KCE_WirelessCAN_MaxxECU.zip

Included

Easyfit Transmitter, 2 paddle switches fitted to the carbon fibre paddle plate
2 carbon fibre levers & hardware
2 sets of magnets to adjust the pull feel
Transmitter battery
CAN-signalling Receiver
120Ohm CAN termination resistor (fitted or loose)
USB cable
Installation instructions

Optional

8-pin 0.7m loom or 8 pins & housing

Hardware Features

CAN output from left and right hand paddle switches to your CANbus
Compatible with all major CAN systems
2 IP67 rated paddle switches with potted contacts
2 sets of magnets to adjust the pull feel
Choice of carbon fibre paddle levers
Carbon fibre paddle mount
Ultimate performance from a 10ms / 100Hz broadcast rate
Ultimate compatibility from 7 simultaneous CAN message formats (LSB, MSB and bitmasking) with free selection of base address, bus speed and identifier length
Re-configurable using the included FREEWheel USB programming software
AMPSEAL connector(s)
IP67-rated USB port with rubber cap
Flame-retardant ABS plastic
Fully conformal coated for environmental protection
Battery life over 5 years
Unique Transmitter ID prevents cross-talk and interference
Wiring loom 20AWG

Driving Features

Momentary

Size & Weight

Paddle Transmitter: bolts straight onto your steering wheel hub and fits all standard bolt patterns on 6 x 70mm, 6 x 74mm and 3 x 50.8mm PCD steering wheels
Paddle Transmitter: 250-300 x 154 x 23mm, 260g including battery and paddle switches
CAN Receiver: 86 x 55 x 35mm, 112g including loom

Availability & Leadtimes

We hold all our components in stock as sub-assemblies and this allows us to build quickly to your exact specification. We ask that you allow 3-5 working days for final assembly and despatch.

Shipping

See our Delivery Information here https://blinkstop.co.uk/shop/delivery

Warranty & Returns

See our Returns policy here https://blinkstop.co.uk/shop/returns

and our Guarantee policy here https://blinkstop.co.uk/shop/guarantee